There is no such thing as a sheltered roof in Hull. The town sits on a peninsula with water on both sides, and from Pemberton Point down through Nantasket, every roof takes wind that inland towns simply never see. Roofing in Hull is its own discipline — and it’s one we practice: our recent Hull project was a condo building roof replacement with new skylights, done under coastal wind conditions with the building occupied.
What survives on a Hull roof
We install every Hull roof to a high-wind spec as a matter of course: six-nail fastening, sealed starter courses at every edge, storm-rated ridge vents that won’t lift, and hand-sealed shingles on cold-season installs. Aluminum and copper flashing replace standard steel, because salt spray reaches everything in this town. For flat and low-slope sections — common on Hull’s multi-families and condo buildings — we install fully-adhered rubber (EPDM) rather than mechanically fastened systems, because adhered membranes give the wind nothing to grab.
Condos and multi-family buildings
Hull has one of the highest concentrations of condo associations and multi-family housing on the South Shore, and we’re set up for that work: sequenced tear-offs so residents keep access, documented daily progress for the association board, and skylight replacement coordinated into the same project (skylights should never outlive the roof around them — replace both at once and the warranty stays clean).
If you’re getting quotes: ask every roofer what fastening schedule and edge-sealing they’ll use. In Hull, the difference between a four-nail and six-nail install is the difference between calling your roofer after the next big storm and not thinking about it at all.
